JBL

GTR-601

Details
Variations

High Performance Mono Car Audio Subwoofer Amplifier

kr 3.500,003500.0 each
Product Actions
Add to cart options
+

In stock and ready to ship

GTR Stadium Amplifiers

Amplifiers with a small footprint and big impact. GTR mono and full-range, multi-channel amplifiers deliver the efficiency and power you expect from Class D amps—and the performance you expect from JBL. Each model in the lineup will accept both high-level or low-level inputs, allowing the JBL Stadium amplifiers to be added to virtually any car audio system, including factory installed systems. The 2-, 4- and 5-channel amplifiers offer Bluetooth® audio streaming, exclusive Clari-Fi™ music restoration technology that analyzes and improves the audio quality of compressed files in real time, a multi-pairing Party Mode that lets anyone in the car stream music, and a cabin-mounted control panel. GTR amplifiers give you the power to shape your car audio experience in new ways.

Item# GTR-601

General Specifications

Peak Power 1500W

Audio Specifications

2-Ohm Power Output 600Wrms x 1, <0.1% THD+N
Signal-to-Noise Ratio >80dB (ref 1W output @ 2 )
4-Ohm Power Output 380Wrms x 1, <0.1% THD+N
Click here for a complete list of all specs for this product

Spec Sheet (EN)

2 MB
  • 1 amplifier
  • 2 spare fuses
  • Owner’s manual

Search Result For ""

Would 2 S2-1224 subs work with this amp?

Asked by: Nickan
According to the rms specs on the S2 Subs, this amp can push two S2 Subs and sound more than decent if you take into consideration the Amplifiers Dynamic Output.
Answered by: Ruben from AZ
Date published: 2017-02-20

Can I adjust the power output? Because it outputs 600W at 2ohms, its too much for one S3-1224, or is it better to go with gtx500?

Asked by: mihaS
The S3-1224 handles up to 500W at 2/4 ohms. The GTX-500 would be a better fit since it drives 500W at 2-ohms.
Answered by: Miko at Customer Service
Date published: 2017-04-20

Can I wire up a single Alpine SWR-10d2 to this amp at 4 ohms?

Asked by: Zmannn05
As long as the Alpine SWR-10d2 can handle 380Wrms at 4 ohms, it will work fine with the GTR-601.
Answered by: Joe G at Customer Service
Date published: 2017-07-07

Can those amp push 2 12inches memphis mojo?

Asked by: TeeDawg
With each speaker set at 4 ohms, the amplifier will see a 2 ohm load and will put out a maximum of 600 watts (300 watts to each speaker). 300 watts is more than enough to drive your speakers. The questions is; is it enough for your listening taste? If you are looking to get the subs to play as loud as they can possibly play, you will need a more powerful amp. But if the volume that 600 watts produces is enough for you, this amp will do a fine job driving your speakers.
Answered by: Memen at Customer Service
Date published: 2017-03-15

Is the GTR -601 amp a D series amp &amp; how many watts is it&nbsp;

Asked by: btbtbt
The GTR-601 is a class D Amplifier. Every GTR amplifier, including the full-range models, is a Class D. These high-efficiency, low-heat amps generate a lot of power without drawing much current, and feature small footprints. This amplifier puts out 380 watts of RMS power at 4 ohms, and 600 watts of RMS power at 2 ohms.
Answered by: Joe G at Customer Service
Date published: 2017-02-17

When wiring a single 4 ohm dvc subwoofer @ 2 ohms, do you bridge the GTR-601 to get 600 watts RMS or just use either set of outputs?

Asked by: George O
This is a mono amplifier, so there is no possibility for bridging. The two sets of speaker terminals are simply for convenience, in case you want to connect two speakers to this single-channel amp. So, to answer your question, if you are connecting only one speaker at 2 ohms, you can connect it to one speaker terminal on the amp, and you will be good to go.
Answered by: Mark at Customer Service
Date published: 2017-06-16

Is the GTR -601 subwoofer amp a D-series amp &amp; how many watts is it? ?

Asked by: bt666
The GTR-601 is a class D Amplifier. Every GTR amplifier, including the full-range models, is a Class D. These high-efficiency, low-heat amps generate a lot of power without drawing much current, and feature small footprints. This amplifier puts out 380 watts of RMS power at 4 ohms, and 600 watts of RMS power at 2 ohms.
Answered by: Joe G at Customer Service
Date published: 2016-06-28

how many watt system is it.

Asked by: nik1207
Memphis M6 have 900 watts and other is Memphis Mojo have 1500 watts.
Answered by: TeeDawg
Date published: 2017-02-17
  • y_2017, m_10, d_17, h_21CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.3
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_8
  • loc_en_NO, sid_gtr-601_, prod, sort_[SortEntry(order=NUM_ANSWERS, direction=DESCENDING)]
  • clientName_jbl
Sharing